Blue Water cruising sailboat Blue Water cruising sailboat


 * Ford Lehman 80 hp diesel completely rebuilt 2009 with 1140 hours since rebuild.  This is a simple, non-turbo, no electronics, diesel engine
 * Rebuilt injector pump in 2014 – 640 hours
 * New hydraulic transmission installed 2014 - 640 hours
 * Side Power bow thruster installed 2011
 *Next-Gen 5.5 KW diesel genset (3 cylinder Kubota) with remote full   gauge panel installed in 2017 with only 220 hours
 *16,000 BTU reverse cycle, 50/60 Hz aircon in main salon being installed now 
 * 5000 BTU reverse cycle 50/60 Hz aircon in aft cabin installed 2017
 * Three bladed Max Prop with new propeller shaft installed 2011.
 *Autohelm self steering windvane also acts as a complete,   independent auxiliary rudder. Installed 2016
* Mains system is 220V
* 105 amp, dual belt, Leece Neville alternator installed 2016, plus 2 spares.
* Smart 3 stage external regulator installed 2016
* Victron 3000W inverter with integral 140A charger installed 2016
* Victron battery monitor installed 2016
* Bridgeport Magnetics 12 KVA  torrod isolation transformer to accept any dock voltage for world capability. Installed 2016
* 6 ea. x 6V Trojan RE105 lead acid house bank installed 2016 charged via the Victron inverter/charger
* 2 ea. x 8D x 12V lead acid battery bank for bow thruster installed 2017
* Odyssey blue top AGM engine start battery installed 2016
* 700 CCA lead acid Genset start battery installed 2016
* 50A Mastercharge battery charger on bow bank installed 2017
* 20A Mastercharge battery charger on engine start battery installed 2017
* 20A Mastercharge battery charger on genset start battery installed 2017
* Blue Seas remote switched relay, to parallel bow and house battery banks installed 2017
* AC and 12V DC electrical panel installed 2009. 
* New main ships wiring installed 2009
* Six 85 watt solar panels on a MPPT controller installed 2011, 2013 and 2017
* 600 watt wind generator installed 2013 with MPPT controller installed 2016
* Complete mast re-wire in 2011
* DC sub-panel at helm installed 2014
*All LED lights below decks installed 2017
* LED cockpit and spreader lights installed 2017
* New standing rigging and turnbuckles installed 2012
* Mast pulled, repainted and rewired in 2009
* New stainless chainplates manufactured and installed 2012
* Five sails:
       * 2011 UK fully battened mainsail with three reef points
      * 2011 UK staysail with Schaeffer 2100 series furler installed 2011
      * 2011 UK 135% Passagemaker yankee cut genoa with Schaeffer            3100 furler installed 2011 new unused
      * 2013 Tasker heavy duty yankee cut working jib with foam luff
    * North asymmetrical spinnaker (age unknown but in very good condition) with new
* Dousing sock installed 2014
* Garhauer rigid vang installed 2011
* New heavy duty Garhauer traveler installed 2011
* Strong track system for battened main installed 2011
*  Mainsail has Stackpack system with built in lazyjacks.
* Triple reef system is ultra easy to operate, on or off the wind.
* 'Self climber' system for going aloft
* Aluminum ratlines on port lowers installed 2014
* New Stainless lifelines installed 2017
* Aluminium whisker pole
* Lewmar and Harken winches
* New staysail tracks installed 2018
* Raymarine eS127 (12”) hybrid touch multifunction display installed 2018.  Pod mounted on a rotating, articulated knuckle to allow viewing from helmsman cockpit or main cockpit.
      * Interphase 200C stereo forward looking sonar installed 2012
      * Raymarine 600W depth sounder transducer installed 2011
      * 48 mile 4 KW Raymarine digital radar installed 2011.
      *AP26 Simrad hydraulic autopilot installed 2006 with wireless               remote for Autopilot installed 2007. 
       *Class B AIS transponder – (transmit and receive) installed 2018            (VHF also has AIS RX only)
* Raymarine ST-60 wind instrument
* Icom 802 SSB radio with Pactor III USB modem
* Sony 22" flat screen monitor on movable mount to allow for watching movies in the main salon, or use as a nav station monitor.  
* Two VHF radios: one at the helm and one at the nav station.   Icom nav station VHF installed in 2014 is GPS connected for DSC calling, and has AIS.
* Sony stereo with CD & aux inputs with speakers in the cockpit and main salon.
* Raymarine spare unused GPS on stern arch mount
* Backup Garmin hand held GPS
* Uniden hand held waterproof VHF
* Lofrans 1200 watt anchor windlass rebuilt in 2017 with both up
   and down foot switches.
* Paratec Sea Anchor system (never used)
* Custom heavy duty double bow roller system new 2012.
* 88lb Delta primary anchor new 2014 with
* 350' 3/8 chain (plus 50 extra chain stored aft)
* 66 lb Lewmar claw secondary anchor new 2014 with 1" rode.
* Fortress FX 35 anchor with 200' 1" rode
* 35 Lb Danforth high tensile anchor with 150' nylon rode
* Spare 60 lb CQR anchor stored aft
* 10' TITAN aluminum bottom inflatable tender new 2011 with
* Yamaha 9.9 four stroke engine new 2013
* Dinghy chaps (cover) new 2014.
* 6 USG gas tank new 2014 with spare hose,
* Six part motor lifting tackle with davit and heavy duty stern rail mount for outboard
* Custom dual deck storage cradle for dinghy allows for upside down storage of dinghy for offshore or rightside up storage with outboard mounted for inshore cruising. Installed 2018
* Lifesling system
* MOB light and pennant
* 4 unused SOLAS lifejackets new 2016
* Large lot of other lifejackets
* 4 inflatable suspender type lifejackets with harnesses two are 2016 and the other 2 unknown but new cartridges installed 2016
* Handheld Survivor watermaker for ditch bag (ditch bag has duplicate flare and signal kits)
* Two horseshoe bouys
* Lifeline stanchions are 34 inches high and stoutly constructed of 1-1/4 inch stainless steel tubing which is further knee-braced to the high bulwarks.
* Four man Ocean Liferaft new 2012. Serviced 2016
* 406 ACR GPS EPIRB new 2012
* Offshore rain gear for 2 males and 1 female new 2017
* Two electric bilge pumps + manual
* New LPG electric solenoid cut off + alarm system  
 * Comprehensive first aid kit including sutures, stapler, anesthetic, antiboitics, bandages........ 
* Six new Lewmar deck hatches installed 2013, a large traditional teak butterfly hatch, and seven opening ports for terrific ventilation in the tropics
* Five low power consumption Camfro fans installed 2017 – two never used
* 12V Adler Barbour cold plate refrigerator and separate 12V Adler Barbour cold plate freezer,
* Spare unused Barbour reefer unit new 2017    
* Force Ten three burner propane stove with oven and broiler,
* Double, deep, stainless steel sinks, new Moen faucet, and ample counter space
* New head faucets, and two new uninstalled Sandvik shower fixtures
* Enclosed walk-in pantry.
* Magma LPG grill with adjustable food prep counter on stern rail.
* Ritche 6 inch (150mm) compass.
* Ritche hand bearing compass
* Chain and cable steering with new cables new in 2014 (plus spares) and heavy duty emergency tiller.
* Custom stern arch installed 2011 with built in seating for four over stern
* 35 USG holding tank on a new 2017 Trident hose to a y-valve for direct discharge.  Never used
* Macerator pump installed 2017 on a new 2017 Trident hose and never used
* Two new Jabsco heads new 2013 with spares
* 13' two person Pelican kayak with two sets of paddles.
* Two folding bicycles
* New Seaward hot water tank being installed now so never used
* Paper charts for all the Philippines, Fiji, Solomon Islands, and Vanuatu plus other misc charts of Hawaii and the South Pacific
* Navonics charts for the entire South China Sea area
* Cockpit shower installed 2014
* Two aluminium 20 lb propane cylinders
* Two reverse cycle, dual frequency, marine air-con units.  16,000 BTU in main salon and 5000 BTU in aft cabin

* New Foredeck cleats installed 2014
* Reinforced and strengthened rudder post area in 2016
* New propane lines and regulator installed 2015
* Bimini top and a quality dodger with optically clear view windows in nearly new condition (2013).
* Clock(s) and barometer
* Fire extinguishers
* Set of signal Flags
* Fenders, dock lines
* Complete fishing gear including offshore rod, Penn reel, long and short gaffs, and two large bags stuffed with tackle......
* Stainless boarding ladders port and stbd.
* Complete workshop with all the tools one would need to support a cruising boat 
* Spares as listed on the spares page,

A few items are still being installed as part the refit for my now cancelled world cruise.

I likley will not have time to install the 60 USG/Hr water maker system. It features all new components and used a genset mounted General stainless steel high pressure pump controlled by a 12V clutch, and Iwaki low pressure feed pump. Membrane is a single 4 x 60” unit. 
All the main components are on board, the pumps are wired and mounted, but the control valving system requires assembly. 
​  There is a new Seaward hot water tank on board, but not required in the tropics, so I have not installed.